Eachine Novice-IV 4 Inch 3-4S Sub 250g LR Micro Long Range FPV Racing Drone RTF & Fly more w/ EV800DM Goggles Radiomaster TX12 Transmitter

Model: BEITIAN BN-180 GPS

Dimension: 18*18*6mm

Weight: 4.9g

Connector: 1.00mm spacing between the 4pins patch seat

Electrical Characteristics

Chipset: M8030-KT

Receiving Format: GPS,GLONASS,Galileo,BeiDou,QZSS and SBAS

Frequency : GPS L1,GLONASS L1,BeiDou B1,SBAS L1,Galileo 

Channels : 72 Searching Channel

Tracking : -167dBm

Reacquisition : -160dBm

Cold start : -148dBm

Hot start : -156dBm

Position Horizontal : 2.0 m CEP 2D RMS SBAS Enable (Typical Open Sky)

Speed : 0.1m/sec 95% (SA off)

Timing : 1us synchronized to GPS time

Cold Start : 26s

Warm start : 25s

Hot start : 1s

Support Rate : 4800bps to 921600bps,Default 9600bps

Data Level : TTL or RS-232,Default TTL level

Data Protocol : NMEA-0183 or UBX, Default NMEA-0183

Single GNSS : 1Hz-18Hz

Concurrent GNSS : 1Hz-10Hz,Default 1Hz

Model: Eachine Mini M8N GPS

Features: GPS+SBAS or GPS+GLONASS+SBAS

Position Accuracy: 2.0 m CEP

Sensitivity2 Tracking & Nav: –167 dBm

Cold starts: –148 dBm

Hot starts: –156 dBm

Update rate: 5HZ Default, up to 10HZ

Baudrate: 57600

Optimize for Pixhawk and Pixracer running Ardupilot firmware

Size: 20mm*20m*6mm

Weight: 6g

Cold start waiting time: 3~5minutes

Warm start waiting time: 0.5~1.5minutes

Model: Eachine OVX306

Frequency: 5.8G 48CH

Transmitting Power: 0/RCE/25mw/100mw/400mw

Power supply: DC 5V

Current (5v): <650ma (400mw)

Weight: 1.5gram without antenna

Center distance of mounting holes:

25.5mmx25.5mm

Model: Whoop_vtx_HP

Output power: 25~400mw switchable

Frequency: 40CH

Input voltage: 5V

Current consumption: 100mA~400mA(type)

Antenna Connector: U.FL 

Frequency: 5.8GHz 5bands 40 channels

With Raceband

Smartaudio ready

Weight:3g

Continuous working time: around 30minutes

Working mode: Normal Buzzer model or Auto-alarm while Lost main battery.

High-brightness LED indication

100 dBi buzzer 

Input voltage: DC 5V

Size: 18x17x15mm

Weight: 4.3g

DT-B90 90dBi Finder Buzzer

Built-in Battery

Continuous working time: around 30minutes

Working mode: Normal Buzzer model or Auto-alarm while Lost main battery.

High-brightness LED indication

90 dBi buzzer 

Input voltage: DC 4.5-9.0V

Size: 25x16x15mm

Weight: 5.83g

Motor

Mode: NC1404

KV options: KV2750

Configu-ration:9N12P

Stator Diamter:14mm

Stator Length:4mm

Shaft Diameter: Φ1.5mm

Motor Dimension(Dia.*Len):Φ15mm*15mm

Weight(g):9g

Propeller

Material: PC

Weight:1.61g

Pitch:2.4in

Prop Dia:102.33mm

Center Thickness:5.5mm

Center Hole Dia:1.5mm 3 holes

Adaptive Motor:1408-1506

Recommended Motor:1505-3600kv

Colors: Clear Gray

Flight Controller

MCU: STM32F405RGT6 (168MHZ, 1Mbyte FLASH)

Sensor: SPI Sensor MPU6000 for gyro and accelerometer

Barometer: BMP280

UART1/2/6 available

Board size: 33MM * 30MM * 4.5MM

Mount holes: 20MM*20MM

Power supply:3-4S battery input (DC 8V-26V)

Built-in 25A(each) Blheli_S 4in1 ESC

Built-in Betaflight OSD(SPI Control)

Built-in OSD Max Current 100A

Built-in 5V 1.5A BEC

Built-in 9V 1.5A BEC

Built-in 8Mbyte Blackbox

Firmware target: BetaflightF4

Onboard 4in1 ESC

EFM8BB21

Power supply: 3-4S LiPo/LiPo HV (7v/17v)

Current: 25A continuous peak 30A (5 seconds)

Support BLHeliSuite programmable

Factory firmware: F_H_40_REV16_7.HEX

Default protocol: DSHOT600

Caddx Baby Ratel2

Image Sensor: 1/1.8" Inch starlight HDR sensor       

Horizontal Resolution: 1200TVL

TV System: NTSC & PAL  (changeable)

IMAGE: 16:9 & 4:3   (changeable)

WDR: Super WDR (HDR)

Min. Illumination: Starlight

Lens: 18mm

Synchronization: Internal

Electronic Shutter: PAL: 1/50~100,000; NTSC: 1/60~100,000

S/N Ratio : >60dB (AGC OFF)

Video Output: CVBS

FOV: 165 degree

Dimensions: 14mm*14mm*19mm

Weight: 4.6g (N.W.)

Lipo Battery

Capacity:1100mAh

Voltage:15.2v

Continuous Discharge Rate: 50C

Size: 60mmx35mmx25mm

Weight: 90g

Connector: XT30

EV800DM Goggles

Built-in with super HD DVR up to 720*576px resolution

Diversity RaceBand 40ch Auto-Searching 

Two system (Display/recor d duo core separated chipsets ) ensure no delay in displaying and no frame lost in recor ding(please use C10 super speed card to ensure the full frame recor ding)

Work friendly with player-OSD, no block on the important flying OSD information;

Focal length adjustable design;Room for eyeglasses

HD high brightness 3 inch LCD specially tuned for FPV racing;

Diversity function, Built-in super sensitive 5.8GHz 40ch receiver module, with RaceRand;

Advanced auto-searching function and the working frequency show on screen;

Built-in 3.8V 2000mAh battery, each full charge offer 2.2 hours working time;

Wide range re-charge voltage 5-180V;

Accept 2S or 3S batteries as back-up power source, to prolong the working time;

Nice ergonomic design and fit different faces;

Super-wide visible angle up to 82 degree;

92% transparent lens adopted, no distort, no blur on the edge of screen;

Light weight 320g with 2.2 hr 2000mAh battery, RTF for any scale racing game;

3 Inch 900*600px HD high brightness LCD

2.4G Receiver

Brand Name: RadioMaster

Item Name: R81 Nano Receiver

Model: R81

Weight: 2g

Size: 17*11 mm

Channels: 8CH

Frequency range: 2400-2483.5Mhz

Power input range: 4.5-6V

Signal format: FrSky D8 Compatible

Output format: SBUS

Support return: support return RSSI

Control distance: more than 1km

Antenna length: Approximaltly 6cm

Radio Transmitter

Brand Name: RadioMaster

Item Name:TX12 Transmitter

Size:170*159*108mm

Weight: 363g

Frequency: 2.400GHZ-2.480GHZ

RF Chip: Single-chip Multi-protocol（CC2500）

Supported Protocols: Corona, Hitec,  for Futaba S-FHSS,Frsky D16/D8, RadioLink, Graupner HoTT

Transmitting Power: 20dbm

Antenna Gain: 2db

Working Current: [email protected]

Voltage Range:6.6-8.4v DC

Range: > 2km @ 20dbm (depending on receiver)

Radio Firmware: OpenTX（Transmitter）/  Multi-Module（RF module)

Channels: Up to 16 (depending on receiver)

Display:128*64 Monochrome LCD display

Gimbal: High precision potentiometer gimbals

External module:JR/FrSKY/Crossfire compatible

Upgrade Method: USB/SD card* & OpenTX Companion PC software

*SD Card not included.