Attention:
Description:
Item | Specification | |
Eachine Wizard X220S | Wheelbase: 220mm Frame arm: 4mm light material Weigh: 356g (without battery and camera mount) Take off weigh: 561g Package weigh: 1728g Use light composite material.
4mm thickness and 15mm width frame arms, the width is 5mm less than Eachine Wizard X220.
Frame kit with camera angle scale and 30° camera mount for Runcam 3 Gopro session.
Anti-vibration sponges to protect the racer frome crashing.
|
|
Eachine MN2206 2300KV motor |
KV: 2300 Max thrust: 1100G Length: 35MM NO.OF cell: 3-5S Diameter: 28MM Framework: 12N14P Shaft: 3MM Propeller: 5 inch Weight: 28g |
|
Eachine 30A BLHELI_S 4 in 1 ESC | Con. current: 30A Peak current (10S): 35A Input voltage: 2-5S BEC: No Programming: YES Firmware: blheli_s Weight: 28g Size: 36*36MM |
|
Eachine 1179 800TVL CCD camera | Color: purple Sensor: CCD
Resolution(horizontal center): 800TVL
Shell size: 25mm*25mm
Weight: 11g
Resolution: PAL: 1980H×1080 (2MP) NTSC: 1980H×1080V (2MP)
Format: PAL/NTSC switchable
Video output: 1.0Vp-p/75Ω
Automatic gain control: 0.25/0.50/0.75/1.00 adjustable, up to 55dB.
AWB: ON/OFF
Exposure mode: electron exposure
Electronic shutter: 1/50(1/60) - 1/100000 S
Gamma correction: 0.45/1.0
Synchronization method: internal synchronization
Lens: standard 2.8mm lens
Working voltage: DC12V (Wide Voltage, measured that can be work in 5-13V)
Workig current: 70mA (low power consumption)
Workig temperature: -20℃--60℃
Humidity: 0%~98%
Strong backlighting effect |
|
5.8G 72CH 25MW 200mw 600MW
switchable transmitter
|
Video Format : NTSC/PAL Channel: 72CH Operating Temperature : -10~85℃ Connector: SMA Female (Inner hole) Antenna Connector: RP-SMA male (Inner needle) ![]() |
|
BF3.1.5 Omnibus F4 V2 flight controller | Size: 35x35mm
Mounting hole: 30.5x30.5mm
Firmware: betaflight_3.1.5_OMNIBUSF4SD
Input voltage: 2-6S
SCM: STM32 F405 MCU
Sensor: SPI Sensor MPU6000
Berometer: BMP280
Slot: standard SD card slot
BEC: 5V/3A
STM32 F405 MCU, Runs betaflight_3.1.5_OMNIBUSF4SD, could run faster loop time.
Using F4 MCU controls OSD over SPI bus in DMA mode.
OSD Configation has been included in Betaflight GUI. Built-in 5V/3A BEC.
Built-in galvanometer.
With LC filter.
|
|
iRangeX iRX-i6X 2.4GHz 10CH remote control |
Channel: 6-10 (Default 6) Model Type: Fixed-Wing/Glider/Helicopter
RF Range: 2.408-2.475GHz
RF Power: < 20dBm
RF Channel: 135
Bandwidth: 500KHz
2.4GHz System: AFHDS 2A / AFDHS
Modulation Type: GFSK
Stick Resolution 4096
Low Voltage Warning: < 4.2V
DSC port: PS/2 Port PPM
Chargeable: No
Antenna Length: 26mm (Dual Antenna)
Weight: 392g
Power: 6V DC 1.5AA*4
Display: STNTransflective Display, LCD 128x64 Lattice, VA 73x39mm, LCD with white backlight
Size: 174x89x190mm
On-line Update: Yes
Color: Black
Certificate: CE0678, FCC ID: N4ZFLYSKYI6X
|
|
iRangeX iR-A8S receiver |
Channels: PPM 8CH Model type: Multi-rotor Frequency range: 2.408-2.475GHz
Band width: 500KHz
Band number: 135
RX Sensitivity: -92 dBm
2.4GHz system: AFHDS 2A Modulation type: GFSK
DSC port: PPM Transfer method: FHSS Data output: 1.5mm*3 Pin PPM Antenna length: 26mm (Not including brass contacts)
Input power supply: 4.0-8.4V
Display method: LED No ground interference ( Transmitting and receiving 1 m from the ground): >300m Working current: 40mA Each channel data: depend on the transmitter Channel delay: <15mS Size: 20*14*5.3mm Weight: 1.2g
Certificate: CE0678, FCCID: N45ZA8S00
|
|
1500mAH 4S 14.8V 75C battery |
Capacity(mAh) : 1500 Cells (s): 4
Weight (g): 177
Length(mm): 80
Width(mm): 30
Height(mm): 33
Connector: XT60
|
|
Eachine 5051 3-blade propeller | Color: purple Quantity: 10 Pairs Mounting Hole: 5mm |
Package included: